Solid Oak Kitchen Wall Cabinet Specification

We're extremely proud of the quality of our solid oak kitchen cabinets; so much so that we're happy to show them off from every possible angle! We invite customers to explore one of our solid oak base cabinets by utilising the 360° diagram above — please do take some time to experiment and discover the impeccable quality on offer.

Our full cabinet specification is listed below:

18mm solid European oak panels (40mm staves) for carcase sides, shelves, top and base - finger jointed & high pressure glued using the most technologically advanced German CNC machinery.

Manufactured, lacquered & finished in the UK.

18mm solid European oak panels (40mm staves) for carcase sides, shelves, top and base - finger jointed & high pressure glued using the most technologically advanced German CNC machinery.

Manufactured, lacquered & finished in the UK.

3.5mm oak design foil covered medium density fibreboard (MDF) back panels to allow for natural contraction / expansion.

Supplied with a service gap of 10mm..

Wall cabinets come with a single solid oak shelf (additional solid wood shelves can be purchased separately if required). Each standard wall cabinet is pre-drilled with slots to accommodate up to five shelves.

Pre-drilling service available to ease the installation process.

Oak panels supplied fully finished and sanded to 150 grit, with factory furniture 3mm neat edge profile before finishing.

Innovative lacquer finish formulated to provide outstanding resistance to abrasion, wet and dry heat, spirit solutions and a wide range of household chemicals.

Surface finish is stain resistant to household food & drink (including red wine).

Cabinet finish approved to FIRA standard 6250:2005.

Supplied flat packed, with all required fittings.

Easy to assemble — 15 -60 minutes per cabinet — and an assembly instructional booklet is provided with each cabinet. downloadable instructions are also available online.

Clean with a damp cloth and warm soapy water.

Tails provided to support side panel of cabinet (if necessary).

Zinc plated cabinet hanging brackets supplied with wall units (including hangers).

Please note that the actual width of all solid oak cabinets is subject to a +/-2mm tolerance.

Last updated December 2014