800mm - 1200mm Wide Slimline Base Cabinet D300mm Assembly Instructions
IMPORTANT - Please read prior to installation
Thanks for purchasing a solid oak kitchen cabinet. Before you commence installation, please check the contents of this package to ensure that all necessary components are included. Please contact us immediately via email if any parts appear to be missing.
Please ensure that you assemble the goods in a clean, dry area, with plenty of space, and that you have the correct tools and equipment to hand. We recommend that you read the instructions in full before you commence assembly, and if necessary, run through the installation procedure without physically assembling any items before you begin. Only construct one cabinet at a time, and follow the installation stages in order, without modification. During installation, be careful to keep the relevant fittings for the current cabinet together. Do not over tighten screws, and ensure that any larger panels are laid flat and protected.
Clean the cabinets with a damp cloth, and if necessary a small amount of liquid soap, only. Do not use abrasives. We provide a full cleaning and aftercare guide on our website, please view this for further information.
Insert [A] and [E] as shown in the diagram below.
Apply a small drop of glue to each dowel [E] before inserting.
Insert [B] as shown ensuring the arrow marking is pointing towards the outside edge.
Connect the base panel (3) to the side panel (2) using the fittings inserted during steps 1 and 2.
Repeat the process for top panel (3)
Fit support panel (6) using 4 x [E] dowels and secure with 2 x [D] screws
Slide the back panel (4) between the grooves on the inside edge of panels (3)
It is advised that you run a small amount of glue along the grooves first.
Connect the opposite side panel (1) as shown then tighten all fittings [B] by turning in direction of arrow with a screwdriver.
Fitting Cabinet Legs:
Position each foot mount [G] towards the edge of the base panel at each corner. Ensure screw holes are not aligned over the panel join and that the overhand foot support is overlapping the side panel as shown below.
Drill 3mm pilot holes into the base panel through the four mounting holes in each foot mount. Now screw the four [C] screws supplied with each foot directly through the foot mount and into the base panel.
Attach the adjustable legs [H] to each foot mount and adjust to the appropriate height.
Cabinets should be joined between each set of hinge holes on the inside edge of the side panel as shown in the diagram. Mark 25mm as a guide on a 3mm diameter drill bit using masking tape. Drill between the hinge holes into the cabinet side panel (18mm) and 7mm into the next until you reach the marker. Join the two cabinets together using the 25mm screws provided [D]
Push the shelf supports [F] into the pre-drilled shelf holes then sit the shelf on top.
Secure plinth to plinth clip [I] using screw provided (C).
Clip each plinth clip onto the legs [H] at the front of the cabinet.